This is an old revision of the document!
To-Do
Engine/Systems
Install security bolts
Replace motor mount plywood
Depth sounder is dead- repair
motor mount, sliding up, could be lowered a bit?
replace starter battery with storage battery
Mast
Remove lost/dropped halyard blocks from center of mast
Either get 12-20 screws for spreaders or drill out to MM size
Replace masthead lamp with LED lamp
Install baton to lift backstay over sail while tacking?
Sails/Rigging
* Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat
* Forestay- rubs against jib halyard bearing, move it outside of the bearing position or remember to keep backstay loose
* Re-install washers on jib halyard block
Hull
Replace toe-rails
Replace hatch-cover
Install external hatch handle
Replace wood underneath spinnaker barber-haul cleats
Check rudder bearings and shaft condition
Bottom
Reattach (replace?) cockpit floorboards
Sand and varnish tiller
Cabin
Remove old log and fill holes
Glue metal plate back into place under stove hatch - don't think it will last, need screws instead (DIDN'T hold).
File pantry and stove cover doors down to allow for expansion
Re-attach trim to various panels
Floor board reinforce forward port side - completely rebuilding the forward floor boards, will take several gluing sessions and new screws.
Paint inside walls near cabin entrance
Find replacement mast support pole? Need to deal with the top section of the pole, quite a bit of rust.
Sand and varnish walls underneath added deck supports (varnish is peeling)
Install hook under cabin hatch to allow easier spinnaker stowage (have brass hooks, but maybe something with a latch would be better)
Completed