This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
rini:to-do_2011 [2011/03/13 14:32] ben [Misc Info] |
rini:to-do_2011 [2011/04/11 04:49] ben [To-Do] |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | |||
==== Misc Info ==== | ==== Misc Info ==== | ||
Line 9: | Line 10: | ||
==== To-Do ==== | ==== To-Do ==== | ||
- | |||
- | === Long-term === | ||
- | * Safety lines - or at least a bow pulpit | ||
- | * Lazy jacks? | ||
- | * Window replacement | ||
- | * Find replacement mast support pole? Need to deal with the top section of the pole, quite a bit of rust. | ||
- | |||
=== Engine/Systems === | === Engine/Systems === | ||
Line 25: | Line 19: | ||
=== Mast === | === Mast === | ||
- | + | * New Windex | |
- | * Remove lost/dropped halyard blocks from center of mast | + | * <del>Remove lost/dropped halyard blocks from center of mast</del> DONE! |
- | * Either get 12-20 screws for spreaders or drill out to MM size | + | * <del>Either get 12-20 screws for spreaders or drill out to MM size</del> Drilled and tapped to M6! |
* Replace masthead lamp with LED | * Replace masthead lamp with LED | ||
* Install baton to lift backstay over sail headboard when tacking? | * Install baton to lift backstay over sail headboard when tacking? | ||
+ | * Forestay- rubs against jib halyard sheave, move it outside of the sheave position or remember to keep backstay loose (Found a suitable piece of steel to use to move the stay forward a centimeter or two) | ||
+ | * Replace lower boom kicker bracket (maybe upper too?) with something more sturdy | ||
=== Sails/Rigging === | === Sails/Rigging === | ||
* Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat | * Shorten lower boom kicker length and re-attach (will allow more downward movement), need hacksaw and riveter at the boat | ||
- | * Forestay- rubs against jib halyard bearing, move it outside of the bearing position or remember to keep backstay loose | + | * <del>Re-install washers on jib halyard block</del> |
- | * Re-install washers on jib halyard block | + | |
* **New sail cover** | * **New sail cover** | ||
=== Hull === | === Hull === | ||
- | * Patch small paint crack just above water line on starboard side near stern | + | * <del>Sand and</del> varnish tiller, needs two more coats |
* Replace toe-rails | * Replace toe-rails | ||
* Replace hatch-cover | * Replace hatch-cover | ||
* Install external hatch handle | * Install external hatch handle | ||
* Replace wood underneath spinnaker barber-haul cleats | * Replace wood underneath spinnaker barber-haul cleats | ||
- | * Check rudder bearings and shaft condition | ||
- | * Bottom | ||
* Reattach (replace?) cockpit floorboards | * Reattach (replace?) cockpit floorboards | ||
- | * Sand and varnish tiller | + | * Patch random cracks on deck & in cockpit |
=== Cabin === | === Cabin === | ||
Line 60: | Line 53: | ||
* Sand and varnish walls underneath added deck supports (varnish is peeling) | * Sand and varnish walls underneath added deck supports (varnish is peeling) | ||
* Install hook under cabin hatch to allow easier spinnaker stowage (have brass hooks, but maybe something with a latch would be better) | * Install hook under cabin hatch to allow easier spinnaker stowage (have brass hooks, but maybe something with a latch would be better) | ||
+ | |||
+ | === Long-term === | ||
+ | * Safety lines - or at least a bow pulpit | ||
+ | * Lazy jacks? | ||
+ | * Window replacement | ||
+ | * Find replacement mast support pole? Need to deal with the top section of the pole, quite a bit of rust. | ||
==== Completed ==== | ==== Completed ==== | ||
+ | * Weld tiller bracket back together | ||
+ | |||
+ | === Hull === | ||
+ | |||
+ | * <del>Patch small paint crack just above water line on starboard side near stern</del> | ||
+ | * <del>Check rudder bearings and shaft condition</del> Should be okay for a long time to come. | ||
+ | * <del>Bottom paint</del> | ||
+ | |||
+ | ==== Bottom painting supplies ==== | ||
+ | |||
+ | * <del>masks</del> | ||
+ | * <del>gloves</del> | ||
+ | * <del>scrapers</del> | ||
+ | * <del>masking tape</del> | ||
+ | * <del>drop cloths</del> | ||
+ | * <del>containers to mix epoxy paint (that won't melt, tin cans maybe)</del> | ||
+ | * <del>sand paper</del> | ||
+ | * <del>sanding blocks</del> | ||
+ | * <del>beer</del> | ||
+ | * <del>bourbon</del> |